The Horse Pot Silicone Mold of our own production is made of European quality silicone. THE HORSE COMES OUT OF THE MOLD SMOOTH! IN THE PHOTO IT IS PAINTED WITH A SPONGE

‼️ INSTRUCTIONS FOR WORKING WITH THE MOLD ‼️

This silicone mold has technical holes inside for air drainage so that the tail and chin are poured without bubbles. On finished products, these places are easy to sand.

❗️IMPORTANT! In order for the air to come out through the hole, you need to pour a LIQUID MIXTURE like water into the mold. A thick mixture is not suitable, because it will only clog these holes, freeze right in them and the air will not come out.

Pour the mixture into the mold, coat it. Make sure that the gypsum passes through the air vents. Put on the formwork. Take it out after 40 minutes, first carefully open the mold, pulling it away from the gypsum. Then start with the tail. Pull the tail up first.

❗️ After each pouring, do not forget to use a stick to remove the gypsum residues from the air vent. Otherwise, you may not be able to pour the next pour if you do not pull them out. On the finished horse, sand the places where the air vents were.

Dimensions of the finished product:
- height of the pot 133 mm
- length 173 mm
- width 60 mm
- inner hole 51x37 mm (our wicks 8 mm are suitable)
- mold volume 580 ml
- wax volume to the edge 60 g.